Clothing manufacturer

clothing manufacturer

clothing manufacturer

clothing manufacturers

apparel manufacturers

garments manufacturer

garments manufacturers

garments factory

fashion clothing manufacturer

fashion clothing manufacturers

Logistic & Shipment

cloth manufacturer

clothes manufacturer

clothing manufacturer

clothing manufacturer

clothing manufacturers

apparel manufacturers

garments manufacturer

garments manufacturers

garments factory

fashion clothing manufacturer

fashion clothing manufacturers

Logistic & Shipment

cloth manufacturer

clothes manufacturer

clothing manufacturer

clothing manufacturer

clothing manufacturers

apparel manufacturers

garments manufacturer

garments manufacturers

garments factory

fashion clothing manufacturer

fashion clothing manufacturers

Logistic & Shipment

cloth manufacturer

clothes manufacturer

clothing manufacturer

clothing manufacturer

clothing manufacturers

apparel manufacturers

garments manufacturer

garments manufacturers

garments factory

fashion clothing manufacturer

fashion clothing manufacturers

Logistic & Shipment

cloth manufacturer

clothes manufacturer

clothing manufacturer
clothing manufacturer
clothing manufacturers
apparel manufacturers
garments manufacturer
garments manufacturers
garments factory
fashion clothing manufacturer
fashion clothing manufacturers
Logistic & Shipment
cloth manufacturer
clothes manufacturer

clothing manufacturer

clothing manufacturers

apparel manufacturers

garments manufacturer

garments manufacturers

garments factory

fashion clothing manufacturer

apparel manufacturer

How to Remove Defective Parts or Layer from a Cut?

How to Remove Defective Parts or Layer from a Cut?


It is normal that you may found defects like holes or cut in fabric at the time of layering. But defective garment components should not move or pass to stitching floor. In this article I have explained the way how you can resolve this issue.

The standard procedure of fabric checking is to mark holes or other defects with red sticker or visible colored chalk. It is done this way so that layer-men know where in a layer a defect are located. Once defects are get noticed based defect size a layer-man take decision on how to handle defective layers. If your fabric checker does mark the defects in fabric during checking, ask them to follow this method. Otherwise layer-man can skip defects at the time of layering and there is a chance of having bundles with defective panels.

When you found holes in a fabric layer during spreading of the fabric you have two options to get cutting without holes or remove defective parts from bundles.

1. When layer-men notice holes in a layer, cut the fabric across width at hole and do splicing of layers. In this method your fabric consumption will increase a little bit but you don't get cut component without holes on it. And no need to change parts later.

2. Lay fabric as it is. I mean with defects. Put a colored fabric strip across width and length of the lay on holes. Later when you do shorting of cut panels, reach to the defective panel through colored strip, remove it from bundle and replace it with new panels. When you replace a component be careful to cut a component from end bits of the same fabric lot to avoid shade variation in a garment.